Fujitsu ETERNUS DX80 S2 User's Manual & Installation Instructions page 97

Chapter 5 Setup
5.1 Basic Setup
8
Set the network environment.
Set the ETERNUS DX Disk storage system environment for network communication.
8-1
Click the [IPv4 Settings] tab to specify an IPv4 address. Click the [IPv6 Settings] tab to specify an
IPv6 address.
8-2
Enter the necessary items such as the IP address of the MNT port, and click the [Next>>] button.
To allow connection to devices in a network to which the ETERNUS DX Disk storage system does not
belong, set "Gateway" and specify the IP address (network address) or the connect IP address of
the connection destination device in "Allowed IP List". Click the [Add] button in the "Allowed IP
List" field and register the IP address (network address) or the connect IP address in the Add Allow
IP screen.
A confirmation screen appears.
8-3
Click the [OK] button.
The network setting is applied and the setting completion screen appears.
8-4
Click the [Done] button.
The [Logout] screen appears.
ETERNUS DX80 S2/DX90 S2 Disk storage system User's Guide -Installation-
97
Copyright 2013 FUJITSU LIMITED P3AM-4832-07ENZ0