Fujitsu ETERNUS DX80 S2 User's Manual & Installation Instructions page 109

Chapter 5 Setup
5.1 Basic Setup
■ For SAS host groups
Procedure
1
Click the [Connectivity] tab on the navigation of the ETERNUS Web GUI screen.
2
In [Action], click "Add SAS Host Group".
The [Add SAS Host Group] screen appears.
3
Enter a host group name to be created, and select a host response to be assigned to the
host group.
4
Register a SAS host in a host group and click the [Add] button.
The following screen shot shows registration of a host by clicking the [Now Connected] tab.
A confirmation screen appears.
5
Click the [OK] button.
The SAS host group is added and the registration completion screen appears.
6
Click the [Done] button.
The screen display returns to the [Host Group] screen.
5.1.6.2 Port Parameter Settings
Set the connection information between the host interface port and the server.
The procedure to set the port parameters is as follows.
The screens for setting port parameters vary depending on the host interface port that is being used.
ETERNUS DX80 S2/DX90 S2 Disk storage system User's Guide -Installation-
109
Copyright 2013 FUJITSU LIMITED
End of procedure
P3AM-4832-07ENZ0