Fujitsu ETERNUS DX80 S2 User's Manual & Installation Instructions page 113

Chapter 5 Setup
5.1 Basic Setup
■ For SAS ports
Set the connection information for the SAS ports on the ETERNUS DX Disk storage system and the server.
Procedure
1
Click the [Connectivity] tab on the navigation of the ETERNUS Web GUI screen. On the
[Connectivity] screen, click "SAS" under "Port Group" in [Category].
The [SAS Port Group] screen appears.
2
Select the checkbox for the SAS port to set the port parameters for in the [SAS Port Group]
screen and then click "Modify SAS Port Parameters" in [Action].
The [Modify SAS Port Parameters] screen appears.
3
Set the required items and click the [Set] button.
A confirmation screen appears.
4
Click the [OK] button.
The port parameter is set and the setting completion screen appears.
5
Click the [Done] button.
The screen display returns to the [SAS Port Group] screen.
5.1.6.3 CA Port Group Creation
Create a CA port group for a host to access the ETERNUS DX Disk storage system. A CA port group is a group of
host interface ports that have the same interface and connect to the specific host group.
Only host interface ports with "CA" or "CA/RA" can be registered in a CA port group.
For details about port mode settings, refer to "ETERNUS Web GUI User's Guide".
ETERNUS DX80 S2/DX90 S2 Disk storage system User's Guide -Installation-
113
Copyright 2013 FUJITSU LIMITED
End of procedure
P3AM-4832-07ENZ0