Fujitsu Eternus DX60 S2 User Manual page 73

Chapter 4 Connecting Cables
4.5 Power Cord Connection
Procedure
1
1-1
1-2
FUJITSU Storage ETERNUS DX60 S2 Disk storage system User's Guide -Installation-
Connect the power cord to the ETERNUS DX Disk storage system.
Each enclosure has two power supply units (PSU#0 and PSU#1).
IMPORTANT
The power cords must be connected to the inlets of both power
supply units.
Connect the power cord plugs to the power inlets of the power supply units.
PSU#0
Power cord plug
Fix the plug of the power cord with the release tie.
Wrap the release tie around the power cord and fasten the release tie from either side.
Make sure that the release tie is not loose.
Release tie
Copyright 2014 FUJITSU LIMITED
PSU#1
Inlet
73
P3AM-5502-05ENZ0