Fujitsu Eternus DX60 S2 User Manual page 53

Chapter 3 Rack Installation
3.2 Installing Controller Enclosure
2
3
■ 2.5" type controller enclosure
FUJITSU Storage ETERNUS DX60 S2 Disk storage system User's Guide -Installation-
The M5 screw positions for the rack rails are determined relative to the controller
enclosure base line.
Insert the M5 screws in the 1st and 3rd holes on the front and rear rack pillars above
the base lines to fasten the rack rails.
[Left]
3rd position
(M5 screws)
2U
Controller enclosure
1st position
(M5 screws)
controller enclosure
(3)
Tighten the M4 screws of the rack rails that were slightly unscrewed in
Install the controller enclosure in the rack.
CAUTION
•
Fix the controller enclosure in the rack.
(1)
Use the thumb screw to fasten the front right of the controller enclosure to the rack.
Thumb screw
Copyright 2014 FUJITSU LIMITED
[Right]
3rd position
(M5 screws)
1st position
(M5 screws)
Base line of
Rack rails
(Brackets)
Do
When installing or removing the controller enclosure to or from
the rack, make sure to have the right and left sides and the
bottom of the controller enclosure by two or more people.
Failure to do so may cause injury.
(Rear rack pillars)
53
Step (1).
P3AM-5502-05ENZ0