Figure 1.8 Connection Example When The Ip Address Of The Slave Cm Is Set (And A Dedicated Remote Support Port Is Used) - Fujitsu Eternus DX60 S2 User Manual

Chapter 1 Preparation
1.1 Connection Preparation
FUJITSU Storage ETERNUS DX60 S2 Disk storage system User's Guide -Installation-
• Connection example with a dedicated remote support port
- For the ETERNUS DX Disk storage system, three IP addresses are
required (two IP addresses for the MNT ports and one IP address for
the RMT port).
- An IP address is required for a PC terminal that is used for
maintenance operations performed by a maintenance engineer.
- Network devices such as LAN switches are required for operation
management.
- Four enhanced Cat-5 twisted-pair type LAN cables are required (two
for connection to the remote support center and two for connection to
the LAN for operation management).
SNMP
Administration
manager
terminal
LAN switch
PC terminal used for maintenance
IP:y.y.y.c IP:x.x.x.a
CM#0
Controller enclosure
ETERNUS DX Disk storage system
Operation is performed with separate LANs for the MNT port and the RMT port.
The IP addresses of both the Master CM and Slave CM are set.
: Enhanced Cat-5 twisted-pair type LAN cables
Figure 1.8 Connection example when the IP address of the Slave CM
is set (and a dedicated remote support port is used)
22
Copyright 2014 FUJITSU LIMITED
Mail server NTP server
LAN for operation management
IP:x.x.x.d
This PC terminal is used for maintenance operations.
IP:x.x.x.b
CM#1
Remote support
center
Router
P3AM-5502-05ENZ0