Lan Cable Connection (For Iscsi) - Fujitsu Eternus DX60 S2 User Manual

Chapter 4 Connecting Cables
4.2 Host Interface Connection
3
3-1
3-2
4.2.2

LAN Cable Connection (For iSCSI)

Connect the ETERNUS DX Disk storage system to the connection destination with LAN cables
(enhanced Cat-5 type).
LAN cables must be obtained separately.
IMPORTANT
The following explains how to connect the LAN cable.
IMPORTANT
FUJITSU Storage ETERNUS DX60 S2 Disk storage system User's Guide -Installation-
Connect the connector at the other end of the FC cable to the connection
destination.
Remove the covers from the FC cable connectors.
Insert the FC cable connector to the connection destination.
• When using iSCSI connections via LAN switches for connecting to the
server, using different LAN switches to divide the networks is
recommended for connecting the server and the ETERNUS DX Disk
storage system and for operation management in order to maintain
system performance.
• The iSCSI interface operates in 1000Base-T full-duplex mode.
• To help with LAN cable management and prevent incorrect connections,
attach labels to the LAN cables and make a note of connection origins
and destinations.
• When connecting LAN cables, check the connector orientation and then
firmly push it all the way in.
When disconnecting LAN cables, depress the tab, then pull out the
connector.
This section describes dual controller type as an example. Note that there
is only controller 0 (CM#0) for single controller type.
Copyright 2014 FUJITSU LIMITED
66
End of procedure
P3AM-5502-05ENZ0