Figure 1.6 Connection Example With A Dedicated Remote Support Port - Fujitsu Eternus DX60 S2 User Manual

Chapter 1 Preparation
1.1 Connection Preparation
●
Connection example with a dedicated remote support port
Use RMT ports when the network connection for remote support needs to be separated from
the company LAN.
-
-
-
-
Operation is performed with separate LANs for the MNT port and the RMT port.
Figure 1.6
FUJITSU Storage ETERNUS DX60 S2 Disk storage system User's Guide -Installation-
For the ETERNUS DX Disk storage system, two IP addresses are required (one IP
address for the MNT port and one IP address for the RMT port).
An IP address is required for a PC terminal that is used for maintenance operations
performed by a maintenance engineer.
Network devices such as LAN switches are required for operation management.
Four enhanced Cat-5 twisted-pair type LAN cables are required (two for connection to the
remote support center and two for connection to the LAN for operation management).
Administration SNMP
terminal
manager
LAN switch
PC terminal used for maintenance
IP:y.y.y.c IP:x.x.x.a
CM#0
Controller enclosure
ETERNUS DX Disk storage system
: Enhanced Cat-5 twisted-pair type LAN cables
Connection example with a dedicated remote support port
Copyright 2014 FUJITSU LIMITED
Mail server NTP server
LAN for operation management
IP:x.x.x.d
This PC terminal is used for maintenance operations.
CM#1
Remote support
center
20
Router
P3AM-5502-05ENZ0