Fujitsu Eternus DX60 User Manual page 181

Chapter 6 Operation and Troubleshooting
> 6.5 Troubleshooting
When an IP address is forgotten
Set a new IP address according to the following procedure.
Procedure
1
2
3
4
When the license key cannot be registered
A wrong serial number may have been input when issuing the license key. If the problem per-
sists, contact your sales representatives.
When issuing the license key again, make sure to check that [SER.NO.] (device serial number)
that is described in the notification E-mail is correct.
When an ETERNUS DX60/DX80 related error message is displayed by the server
While you can continue using the ETERNUS DX60/DX80 for any work that is not affected by this
problem, contact your maintenance engineer to determine the cause of the problem.
When volume capacity is short
Volume-adding function (LUN concatenation and RAID migration) and RAID-group-adding func-
tion (Logical Device Expansion function) can be used to resolve the capacity shortage of vol-
umes.
Refer to "ETERNUS DX60/DX80 Web GUI User Guide" for details on how to use these func-
tions.
Refer
Refer to the following sections for details on these functions.
• "1.3.4 RAID Migration" (page 37)
• "1.3.5 Logical Device Expansion" (page 39)
• "1.3.6 LUN Concatenation" (page 40)
P3AM-3042-03ENZ0 ETERNUS DX60/DX80 Disk storage system User Guide
Remove the front cover of the controller enclosure.
For how to remove the front cover, refer to
Cover" (page 58).
Press the IP RESET Switch twice in a row within two seconds.
The setting information related to the network is returned to the factory default.
Set a new IP address and other network information via GUI or CLI.
Write down the newly set IP address on the Network Setting label.
"ETERNUS DX60/DX80 Web GUI User Guide"
"2.2.3 Attaching and Removing the Front
181
End of procedure
Copyright 2009 FUJITSU LIMITED