Chapter 4 Setup
>
4.2 Cable Connection
2
2-1
2-2
P3AM-3042-03ENZ0
ETERNUS DX60/DX80 Disk storage system User Guide
When two or more drive enclosures are installed, connect the drive enclosures
with the miniSAS cable.
Connect the SAS (OUT) port at expander 0 (EXP#0) of the drive enclosure 1, to the
SAS (IN) port at expander 0 (EXP#0) of the drive enclosure 2 with the miniSAS cable.
(1) Connect the plug to be connected to the SAS (OUT) port, to the SAS (OUT) port of
the expander 0 (EXP#0) for the drive enclosure 1.
Drive
enclosure 1
(2) Connect the connector to be connected to the SAS (IN) port, to the SAS (IN) port of
the expander 0 (EXP#0) for the drive enclosure 2.
Drive
enclosure 2
For dual controller model, connect the SAS (OUT) port at expander 1 (EXP#1) of the
drive enclosure 1, to the SAS (IN) port at expander 1 (EXP#1) of the drive enclosure 2
with the miniSAS cable.
Connect the miniSAS cable in the same way as
The following figure shows the miniSAS connection figure between drive enclosures.
Do not connect anything to the SAS (OUT) port on the end edge.
IMPORTANT
Step
98
2-1.
Copyright 2009 FUJITSU LIMITED