Specifications - Sanyo MCO-18AIC Service Manual

SPECIFICATIONS

Name
Model
External dimensions
Internal dimensions
Interior volume
Exterior
Interior
Outer door
Inner door
Tray
Access port
Insulation
Heating system
Heater
Humidifying system
Temperature controller
Temperature display
CO controller
2
CO density display
2
Air circulation
Air filter
Water level sensor
Alarm
Remote alarm contact
CO inlet connection
2
CO inlet pressure
2
Accessories
Weight
Optional accessory
Maximum power
consumption
Total maximum
current
Note: Design or specifications will be subject to change without notice.
The ballast is not user replaceable part. Please contact a qualified service personnel.
Polyester finish baked on zinc galvanized steel
Stainless steel containing copper
Acrylic finish baked on zinc galvanized steel
4 trays made of stainless steel containing copper
W450 x D450 x H12 (mm), Maximum load; 7 kg/tray
Inner diameter; 30 mm, On the back side
Rigid polyurethane foamed-in place (CFC-FREE)
DHA system (heater jacket + air jacket system)
Natural evaporation with humidifying pan
0.3 µ m, Efficiency; 99.97% or more
High/Low temperature alarm, CO
Door alarm, UV lamp failure alarm
Allowable contact capacity: DC 30 V, 2 A
0.03MPaG (0.3kgf/cm
4 trays, 4 sets of tray support, 1 gas tube, 1 humidifying pan,
Stacking plate A and B (fixed on rear of the unit), 4 protective stickers, 2 tube bands
CO
Automatic CO
Extra tray (MCO-46ST) including 2 tray supports, Half tray (MCO-25ST)
UV system kit (MCO-18UVS), Roller base (MCO-18RB)
UV lamp replacement kit (MCO-20UV)
110 to 120 V, 60 Hz
2.8 A
CO Incubator
2
MCO-18AIC
W620 x D710 x H900 (mm)
W490 x D523x H665 (mm)
170 L
Tempered glass
314 W
PID control system
Digital display
PID control system
Digital display
Fan assisted
Optical type
density alarm, Upper limit temperature alarm
2
4 to 6 mm diameter tube
2
G, 4.3psiG)
93 kg
cylinder regulator (MCO-100L)
2
cylinder changeover system (MCO-21GC)
2
310 W
220 V, 60 Hz
1.4 A
81
220 to 240 V, 50 Hz
1.4 A
35