The "Parameters" Tab - Siemens SIMATIC Ident Operating Manual

Operating the software
5.4 The tabs of the RF620R/RF630R readers
The transmit power of ANT1 is shown as a black line and the transmit power of ANT2 as a
violet line.
Note
Time stamp of the transmit/radiated power
The time stamp for the transmit/radiated power is generated by the diagnostics tool. This
means that there may be slight deviations in the times of RSSI measured values and the
times of the measured transmit/radiated power.
5.4.6

The "Parameters" tab

The "Parameter" tab is displayed only in the advanced view.
With the "Parameter" tab, you can activate, read out, enter, adapt and write the various
parameters and store them on the reader. This gives you the option of generating different
configurations and loading them again later. Laborious manual re-entry of configurations is
therefore unnecessary.
Figure 5-13
You will find a description of the UHF algorithms and the individual parameters in "Parameter
assignment manual RF620R/RF630R
(http://support.automation.siemens.com/WW/view/en/33287195)".
58
The "Parameters" tab
Operating Manual, 09/2012, C79000-G8976-C292-01
SIMATIC RF-DIAG