Connection And Disconnection To Ts-890S; Setting Tx Operation For Use In Arcp-890 And Checking Modulation Line - Kenwood TS-890S Setting Manual

Select the speaker and microphone to use from the drop-down list.
Next, set "Voice quality" of "TS-890S Built-in VoIP". The default is "High Quality Sound". If
the sound is interrupted frequently or the connection with the TS-890S is disconnected
during operation, switch to "Low Quality Sound ".
Next, set "fluctuation absorption buffer". The default is "80 ms". Adjust this item when there
is a problem with the voice quality of VoIP. Selecting a shorter time reduces the audio delay
but noise is more likely to occur due to missing audio packets or the like. Selecting a longer
time increases the audio delay but noise occurrence due to missing audio packets or the like
is potentially reduced. Set the value as small as possible within a range that does not affect
the operation.
After setting, click "OK" button and close "Configure VoIP" window.
Tips:
Depending on the OS used on the PC, clicking the "VoIP setting" button may open the
"Windows Security Alert" window. Click "Allow access" to advance the setting.
(For details on this window display, see "4.5.1. Windows Firewall Settings")

4.3.5. Connection and disconnection to TS-890S

When you click the "Connect" button in the main window of ARCP-890, the indicator will light
green and communication with the TS-890S will start. You can disconnect by clicking the
"Connect" button during connection.

4.3.6. Setting TX Operation for use in ARCP-890 and checking modulation line

Set whether the transmission operation from ARCP-890 corresponds to SEND/PTT operation
of the TS-890S or DATA SEND operation. In order to operate with the contents set in
TS-890S in the chapter "4.2.9. Configuration of the Input Path of TX Audio", set "DATA
SEND" for TX operation for use in ARCP-890.
When you are connected to the TS-890S and selecting "Select Modulation Line" from the
31