Setting The Delay By Tx To Rx Transition - Kenwood TS-890S Setting Manual

55
As shown in the above figure, select "DATA SEND" for "TX Operation for use in ARCP-890".
For the setting of the modulation line, the contents set in TS-890S are displayed as they are
in the chapter "5.2.6. Configuration of the Input Path of TX Audio". As shown in the figure
above, when sending by DATA SEND (PF), make sure "ACC 2" is selected for audio input
from rear panel.
After setting and checking, click the "Close" button to close the window.

5.4.6. Setting the delay by TX to RX transition

When remote control is performed by Internet connection, the last part of the transmitted
voice may be interrupted at the end of transmission. This is due to delay in voice
transmission by VoIP.
In order to prevent this, it is possible to delay the timing of switching from transmission to
reception when performing the transmission end operation with ARCP-890.
When you are connected to the TS-890S and selecting "Select Modulation Line" from the
"TX/RX" menu of ARCP-890, the "Select Modulation Line" window will be displayed.