Setting The Acc 2 Audio Input / Output Level; Setting Beep Mixed Output - Kenwood TS-890S Setting Manual

Also, in order to prevent unintentional transmission during remote control by KNS, set DATA
VOX normally select "Off".
(Note) The "Modulation Source" screen shown in Figure 5.3 can be set separately for DATA
mode Off and DATA mode On. Please set according to the operation mode.

5.2.7. Setting the ACC 2 audio input / output level

In the case of using the audio cable, set the audio input level and the audio output level of
the ACC 2 connector on the rear panel with the menu. You use default values normally.
Adjust the input level of the microphone connected to the PC and the output level of the
speaker, in the setting of the sound device of the PC of the remote station. If it can not be
adjusted with the PC, adjust with the menu of the TS-890S. For the operation method, refer
to the operation manual of the TS-890S.

5.2.8. Setting beep mixed output

With the TS-890S default mode, the audio output from the ACC 2 connector and the USB
connector is not only the received sound, but also beeps and side tones are mixed. The
following menu can be used to prevent beep sound and side tone from being mixed with the
audio output of ACC 2 connector and USB connector.
Fig. 5.3: Configuration the Input Path of TX Audio
Table 5.6 Setting the audio Input/Output level
Menu Item
7-7 ACC 2: Audio Input Level
7-9 ACC 2: Audio Output Level
40