Remote Operation Via The Internet By Conventional System; Conventional System Configuration - Kenwood TS-890S Setting Manual

37

5. Remote operation via the Internet by conventional system

When remotely operating the TS-890S via the Internet, the system described in Chapter 4
uses the VoIP function and the user 's login authentication function built in the TS-890S. In
this system, the TS-890S is connected directly to the Internet, but you can also select a
conventional system connecting the TS-890S to the Internet via a PC (Host PC) installed in
the host station. In this conventional system, ARHP-890 (Radio Host Program) and ARVP-10
(VoIP software) are required.

5.1. Conventional System Configuration

Fig. 5.1: Conventional System Configuration
As shown in the above figure, prepare the PC (Host PC) on the host station side and use
ARHP-890.
Since the VoIP function built into the ARHP-890 does not support remote control by Internet
connection, we use ARVP-10 of VoIP software. ARVP-10H is used on the host PC and
ARVP-10R is used on the remote PC.
* Other VoIP software can be used in place of ARVP-10, but our selection of VoIP software,
installation, setting and operation are not supported by JVC KENWOOD Corporation.