5.2.3. Setting Speaker Mute
If you want to mute the sound output from the TS-890S speaker during remote operation,
set the speaker mute to "On" in the KNS menu. For the operation method, refer to the
operation manual of the TS-890S.
5.2.4. Configuration for KNS Operation
In the KNS menu of the TS-890S, set KNS operation (LAN connector) to "On (Internet)". For
the operation method, refer to the operation manual of the TS-890S.
5.2.5. Timeout timer settings
During KNS operations, control data signals are transmitted using the network. Consequently,
if normal network operations are disabled for any reason, control of the TS-890S will also be
disabled. Use the following menu to set the functions to stop transmitting automatically after
a fixed period if control should be disabled while transmitting.
5.2.6. Configuration the Input Path of TX Audio
In the case of using the audio cable, the audio for transmission is input from the ACC 2
connector. In order to transmit audio from the ACC 2 connector by the transmission
operation from the ARCP-890, set the DATA SEND audio input from the rear panel to "ACC
2" on the "Modulation Source" screen of the TS-890S. (See the screen below)
Table 5.3 Setting Speaker Mute
KNS Menu
Item
7
Speaker Mute
Table 5.4 Configuration for KNS Operation
KNS Menu
Item
1
KNS Operation(LAN Connector)
Table 5.5 Timeout timer settings
Menu
Item
6-02
Time-out Timer
39