Dell Dimension 9200 Service Manual page 31

Documentation
4-3-4 Time-of-day clock stopped
4-4-1 Serial or parallel port test failure
4-4-4 Cache test failure
Message
8042 Gate-A20 error
Address Line Short!
C: Drive Error
C: Drive Failure
Cache Memory Bad, Do Not
Enable Cache
CH-2 Timer Error
CMOS Battery State Low
CMOS Checksum Failure
CMOS System Options Not
Set
CMOS Display Type
Mismatch
CMOS Memory Size Mismatch
CMOS Time and Date Not
Set
http://support.dell.com/support/edocs/systems/dim9200/en/SM_EN/adtshoot.htm (6 of 11) [12/9/2007 11:19:07 PM]
Possible Cause
The keyboard controller failed its
test.
An error in the address decoding
circuitry in the memory has
occurred.
The hard drive is not working or
is not configured correctly.
The cache memory is not
operating.
An error is occurring on the
timer on the system board.
The system configuration
information in the system setup
program is incorrect or the
battery charge may be low.
Corrective Action
If you receive this message after
you make changes in the system
setup program, enter system
setup (see
Entering System Setup)
program and restore the original
value(s).
Reseat the memory modules (see
Removing Memory.
Ensure that the drive is installed
correctly in the computer and
defined correctly in the system
setup program (see
Entering
System Setup).
See "Contacting Dell" in your
Owner's Manual for instructions
on obtaining technical assistance.
See "Contacting Dell" in your
Owner's Manual for instructions
on obtaining technical assistance.
Enter the system setup program
(see Setup), verify
Entering System
the system configuration, and
then restart the computer.