Table of Contents
Advertisement
3-4
Adjusting the Board Positioning Pins (Option)
TURN OFF THE POWER AND THE SERVO SWITCH BEFORE WORKING INSIDE
ACTIVE PART OF THE MACHINE FOR MACHINE SET-UP.
You will have serious injury if the machine is actuated.
M97E
Setting the reference
Check the pin hole or edge for the reference of mount board, and set as follows.
3Y3C-049E
Pin hole reference
Adjusting procedures
Adjust following procedures below.
293C-058E
18A7C0AA
Page 3-8
WARNING
Operating procedures
• Edge reference
Insert pins in following procedures
1
1
90° rotation
2
3
90° rotation
• Pin hole reference
Pull out pins following procedures
1
Positioning pin
Lock bolt
to
on the left.
3
to
on the right.
3
1
. Loosen the lock bolt of pins on the
movable side.
2
. Adjust pins on the movable side
sliding them by hand.
3
. Loosen the lock bolt.
1
90° rotation
2
3
90° rotation
3Y3C-050E
Edge reference
293C-E-EMA03-A01-00
Advertisement
Table of Contents
