Show Static Logical Interface Status - Yamaha L2 Command Reference Manual

124 | Command Reference | Interface control
[Parameter]
link-id
[Input mode]
interface mode
[Description]
Associates the applicable interface with the static logical interface specified by link-id.
If this command is executed with the "no" syntax, the applicable interface is dissociated from the static logical interface.
[Note]
This command can be specified only for LAN/SFP port.
If a LAN/SFP port is associated to a link-id for which a static logical interface does not exist, the static logical interface is
newly generated.
If the associated LAN/SFP port is no longer present because it was removed from the static logical interface, the static logical
interface is deleted.
Up to eight LAN/SFP port units can be associated with one static logical interface.
If it is to be associated with an already-existing static logical interface, all of the following settings must match between the
LAN/SFP port and the static logical interface. If the settings differ, an error occurs.
• speed-duplex command setting
• VLAN setting
If a static logical interface is newly generated, the above settings of the LAN/SFP port are set to the default settings of the static
logical interface.
If a LAN/SFP port is associated with a static logical interface, the MSTP settings return to the default values. The MSTP
settings also return to the default values if the LAN/SFP port is removed from the static logical interface.
It is not possible to associate a single LAN/SFP port with multiple logical interface units. You must use the "no" syntax to first
remove it before associating it with a different logical interface.
[Example]
Associate LAN port #9 with static logical interface #5.
SWR2311P(config)#interface port1.9
SWR2311P(config-if)#static-channel-group 5

5.2.2 Show static logical interface status

[Syntax]
show static-channel-group
[Input mode]
unprivileged EXEC mode, priviledged EXEC mode
[Description]
Shows the static logical interface status.
The following items are shown for each static logical interface that exists.
• static logical interface name
• Load balance function rules
• Interface name of associated LAN/SFP port
For details on the load balance function rules, refer to the type parameter of the port-channel load-balance command.
[Example]
Show the static logical interface status.
SWR2311P#show static-channel-group
% Static Aggregator: sa5
% Load balancing: src-dst-mac
% Member:
port1.9
port1.11
port1.13
port1.15
: <1-96>
static logical interface number