Set Igmp Snooping Fast-Leave; Set Multicast Router Connection Destination - Yamaha L2 Command Reference Manual

210 | Command Reference | IP multicast control
[Example]
Enable IGMP snooping for VLAN #2.
SWR2311P#configure terminal
SWR2311P(config)#interface vlan2
SWR2311P(config-if)#ip igmp snooping enable
Disable IGMP snooping for VLAN #2.
SWR2311P#configure terminal
SWR2311P(config)#interface vlan2
SWR2311P(config-if)#ip igmp snooping disable

8.2.2 Set IGMP snooping fast-leave

[Syntax]
ip igmp snooping fast-leave
no ip igmp snooping fast-leave
[Initial value]
none
[Input mode]
interface mode
[Description]
Enables IGMP snooping fast-leave for the interface.
If this is executed with the "no" syntax, IGMP snooping fast-leave is disabled.
[Note]
This command can be specified only for VLAN interface. Also, this can be specified only if IGMP snooping is enabled.
Do not enable this command on a VLAN interface for which multiple hosts are connected to the LAN/SFP port.
[Example]
Enable IGMP snooping fast-leave for VLAN #2.
SWR2311P#configure terminal
SWR2311P(config)#interface vlan2
SWR2311P(config-if)#ip igmp snooping fast-leave
Disable IGMP snooping fast-leave for VLAN #2.
SWR2311P#configure terminal
SWR2311P(config)#interface vlan2
SWR2311P(config-if)#no ip igmp snooping fast-leave

8.2.3 Set multicast router connection destination

[Syntax]
ip igmp snooping mrouter interface ifname
no ip igmp snooping mrouter interface ifname
[Parameter]
ifname
[Initial value]
none
[Input mode]
interface mode
[Description]
Statically sets the LAN/SFP port to which the multicast router is connected.
If this command is executed with the "no" syntax, the setting is discarded.
[Note]
This command can be specified only for VLAN interface. Also, this can be specified only if IGMP snooping is enabled.
: LAN/SFP port interface name
Interface to set