Set Rmon History Group - Yamaha L2 Command Reference Manual

[Note]
To enable the Ethernet statistical information group setting of the RMON function, it is necessary to enable the system-wide
RMON function in addition to this command.
If this command is overwritten, the previously collected statistical information is deleted, and collection is once again started.
If the system-wide RMON function is disabled, collection of statistical information is interrupted. Subsequently, if the system-
wide RMON function is enabled, the previously collected statistical data is deleted, and collection is once again started.
[Example]
Enable the RMON Ethernet statistical information group settings for port1.1.
SWR2311P(config)#interface port1.1
SWR2311P(config-if)#rmon statistics 1

4.11.3 Set RMON history group

[Syntax]
rmon history index [buckets buckets] [interval interval] [owner owner]
no rmon history index
[Parameter]
index
buckets
interval
owner
[Initial value]
none
[Input mode]
interface mode
[Description]
Enables RMON history group settings for the applicable interface.
If this command is set, it will be possible to acquire the RMON MIB's historyControlTable. After setting this command, history
information is collected at the specified interval, and the RMON MIB's etherHistoryTable can be acquired.
This command can be specified a maximum number of eight times for the same interface.
If this command is executed with the "no" syntax, delete the setting and the collected historical information.
[Note]
To enable the history group setting of the RMON function, it is necessary to enable the system-wide RMON function in
addition to this command.
If this command is overwritten, the previously collected historical information is deleted, and collection is once again started.
If the system-wide RMON function is disabled, collection of historical information is interrupted. Subsequently, if the system-
wide RMON function is enabled, the previously collected historical data is deleted, and collection is once again started.
[Example]
Enable the RMON historical group settings for port1.1.
SWR2311P(config)#interface port1.1
SWR2311P(config-if)#rmon history 1
: <1 - 65535>
Index of history group (historyControlIndex)
: <1 - 65535>
Number of history group items to maintain (historyControlBucketsRequested)
(if omitted : 50)
: <1 - 3600>
Interval at which to save history group items (seconds) (historyControlInterval)
(if omitted : 1800)
: Name of history group owner (historyControlOwner)
Maximum 127 characters
(if omitted : RMON_SNMP)
Command Reference | Maintenance and operation functions | 59