Table of Contents
Advertisement
Installation (continued)
■ Joining the adjustment poles 1 and 2
"FRONT" inscription
Installing the attachment plate to the ceiling
After checking the height, width, and structure of the installation location, determine the appropriate positions for
setting up the screen and installing the projector.
■ Attachment plate mounting hole sizes and preparation
Make mounting holes while referring to the attachment plate diagram.
Install the attachment plate with the
circular hole corner facing the screen.
To the screen
29.5(1-3/16")
Attention
z If installing to a concrete structure, the sizes of the mounting holes should match the sizes of the anchoring
nuts or curled plugs.
z Use commercially available ceiling mount bolts, hex nuts, flat washers, spring washers, and anchoring nuts or
curled plugs.
Adjustment pole 1
Adjustment pole 2
Center of
screen
200 (7-7/8")
259 (10-3/16")
Insert the adjustment pole 1 into the adjustment pole 2,
align the holes, and secure them with the supplied six
captive washer hex head bolts (M6 × 16).
z Align the "FRONT" inscription on the adjustment pole
1 with that on the adjustment pole 2.
Note
z Adjustable screw holes are provided in both
adjustment poles 1 and 2 at 40 mm intervals. Join the
poles to each other by aligning the adjustable screw
holes based on the position for installing the screen
and the adjustment range of the adjustment poles
(451.5 to 531.5 mm).
Bolt mounting hole size
Four holes drilled to fit ceiling
mount bolts (M10)
200 (7-7/8")
<Units: mm (")>
ENGLISH - 7
Hide quick links:
Advertisement
Table of Contents
