Table of Contents
Advertisement
Installation (continued)
Attaching the wire rope to the ceiling
Attach the other end of the wire rope attached to the projector to the ceiling.
*These instructions assume installation in a concrete ceiling and use of M8 ceiling bolts, anchor nuts and curled
plugs. When M10 ceiling bolts, anchor nuts or curled plugs are used, you need to obtain a commercially available
flat washer with a diameter that is 40 mm or larger instead of the flat washer supplied with the projector mount
bracket.
Max. 300 mm (11-13/16'')
Anchoring the nut
or curled plug
*1
Installing to a wooden structure
Ceiling
mount bolt
Ceiling beam
Wire rope
*2
Flat washer
Installing to a wooden structure
Wire rope
*2
Flat washer
*1: Commercially available product
*2: Supplied with the optional projector mount bracket
*3: Use commercially available fasteners or those
supplied with the optional projector mount bracket.
(40 mm in diameter or wider)
12 - ENGLISH
Max. 300 mm (11-13/16'')
Hex nut
*1
*1
Flat washer
Spring washer
*3
Hex head bolt
*1
Spring washer
*3
Hex nut
*1
1) Mount the anchoring nut or curled plug (M8) in the
concrete ceiling (at a single point within the area
shown in the diagram on the left).
z If it is to be attached to a wooden surface, drill
one penetration hole in the ceiling beam for
the ceiling mount bolt, and secure the ceiling
mount bolt using the flat washer (M8)
commercially available hex head bolt (M8).
Attention
z When mounting the anchoring nut or curled plug
(M8) to the ceiling, be careful that there is no slack
in the wire rope between the projector and the
ceiling.
*1
2) Tighten the commercially available hex head
bolt (M8) to the anchor, passing it through the
commercially available spring washer (M8), the flat
washer (M8)
rope.
z If it is to be attached to a wooden surface, pass
the ceiling mount bolt through the ring at the end
*1
of the wire rope as shown to the left, and secure
it firmly to the ceiling beam.
Attention
z Purchase the commercially available anchoring nut
or curled plug, hex head bolt, and spring washer.
Note
z For attaching the wire rope to the projector, refer to
the installation instructions for the separately sold
projector mount bracket.
*1
, and the ring of the end of the wire
*3
*3
and a
Hide quick links:
Advertisement
Table of Contents
