Mitsubishi Electric MELSEC iQ-R Series User Manual page 81

CH1 Comparison output selection
Set whether to use the comparison output function.
For details on the comparison output function, refer to the following.
Page 28 Comparison Output Function
Setting value
0
1
If a value other than those shown in the above table is set, a comparison output selection setting error (error code: 1940H)
occurs.
■Buffer memory addresses
The following shows the buffer memory addresses of this area.
Buffer memory name
CH Comparison output selection
CH Comparison output selection (when Q series-
compatible mode is used)
■Enabling the setting
Turn on and off 'Operating condition setting request flag' (Y1).
■Default value
The default value is Comparison output function invalid (0) for all channels.
CH1 Comparison output setting value
Set the value to compare against the accumulating count value.
For details on the comparison output function, refer to the following.
Page 28 Comparison Output Function
■Buffer memory addresses
The following shows the buffer memory addresses of this area.
Buffer memory name
CH Comparison output setting value
CH Comparison output setting value (when Q series-
compatible mode is used)
■Setting range
• The setting range is from 0 to 99999999.
• For channels on which the set value is outside the setting range, a comparison output setting value setting error (error
code: 1941H) occurs.
■Enabling the setting
Turn on and off 'Operating condition setting request flag' (Y1).
■Default value
The default value is 0 for all channels.
Setting details
Comparison output function invalid
Comparison output function valid
CH1 CH2 CH3
128 160 192
1 33 65
CH1 CH2 CH3
130, 131 162, 163 194, 195
2, 3 34, 35 66, 67
CH4 CH5 CH6
224 256 288
97 129 161
CH4 CH5 CH6
226, 227 258, 259 290, 291
98, 99 130, 131 162, 163
Appendix 3 Buffer Memory Areas
CH7 CH8
320 352
193 225
A
CH7 CH8
322, 323 354, 355
194, 195 226, 227
APPX
79