Mitsubishi Electric MELSEC iQ-R Series User Manual page 91

Interrupt factor reset request [n]
Set whether to send the interrupt factor reset request.
Setting value
0
1
When Reset request (1) is set in 'Interrupt factor reset request [n]' (Un\G664 to Un\G679) corresponding to the interrupt factor,
the interrupt factor of the specified interrupt is reset. After that, 'Interrupt factor reset request [n]' (Un\G664 to Un\G679)
changes to No reset request (0). When the setting value is two or larger, the setting is regarded as Reset request (1).
Turning on and off 'Operating condition setting request flag' (Y1) also resets interrupt factors.
"n" indicates an interrupt setting number. (n = 1 to 16)
■Buffer memory addresses
The following shows the buffer memory addresses of this area.
Buffer memory name 1
Interrupt factor reset request [n] 664
Interrupt factor reset request [n]
(when Q series-compatible
mode is used)
■Default value
The default value is No reset request (0) for all areas.
Interrupt factor generation setting [n]
Set whether to send an interrupt request when the same interrupt factor occurs during the interrupt factor detection.
Setting value
0
1
• If a value other than the above is set, an interrupt factor generation setting range error (error code: 180H) occurs.
• When 'Interrupt factor generation setting [n]' (Un\G696 to Un\G711) is Interrupt resend request (0) and the same interrupt
factor occurs while the interrupt factor has been detected, an interrupt request is sent to the CPU module again.
• When 'Interrupt factor generation setting [n]' (Un\G696 to Un\G711) is No interrupt resend request (1) and the same
interrupt factor occurs while the interrupt factor has been detected, an interrupt request is not sent to the CPU module.
Before sending an interrupt request to the CPU module, set 'Interrupt factor reset request [n]' (Un\G664 to Un\G679) to
Reset request (1) and reset the interrupt factor.
"n" indicates an interrupt setting number. (n = 1 to 16)
■Buffer memory addresses
The following shows the buffer memory addresses of this area.
Buffer memory name 1
Interrupt factor generation 696
setting [n]
Interrupt factor generation
setting [n] (when Q series-
compatible mode is used)
■Enabling the setting
Turn on and off 'Operating condition setting request flag' (Y1).
■Default value
The default value is Interrupt resend request (0) for all areas.
2 3 4 5 6
665 666 667 668 669
2 3 4 5 6
697 698 699 700 701
Setting details
No reset request
Reset request
7 8 9 10 11
670 671 672 673 674
Setting details
Interrupt resend request
No interrupt resend request
7 8 9 10 11
702 703 704 705 706
Appendix 3 Buffer Memory Areas
12 13 14 15 16
675 676 677 678 679
12 13 14 15 16
707 708 709 710 711
APPX
A
89