4) Once the entire surface is dry, press the on/
off switch 6 again to switch the appliance off .
The indicator light 5 goes out .
5) If necessary, dry off any streaks or remaining
moisture on the surface with a dry cloth .
Charging the appliance
NOTE
►
Ensure that the appliance is switched off
before starting to charge the batteries .
■
To charge the appliance, connect the charger t
to a mains socket and insert the connecting jack
r into the charging socket 8 on the motor unit
7 . The control lamp 5 lights up red .
When the appliance is fully charged, the control
lamp 5 lights up blue .
NOTE
►
Only recharge the batteries when the suction
power of the appliance is noticeably weaker
and the red indicator light 5 is flashing red .
Cleaning and care
DANGER – ELECTRIC SHOCK!
►
Prior to cleaning, disconnect the appliance
from the charger t! Risk of electric shock!
ATTENTION! DAMAGE TO PROPERTY!
►
Do not use abrasive or aggressive cleaning
materials . These could damage the surface
of the appliance!
Cleaning the spray bottle
■
Open the spray bottle and empty contents .
Remove the microfibre cover z .
Wipe the components of the spray bottle with
a damp cloth; if necessary, use a little mild deter-
gent on the cloth .
Washing the microfibre cover
The microfibre cover z can be machine-
washed at 60°C . Do not use any fabric
conditioner as this significantly reduces the
cleaning power of the microfibres .
SFR 3.7 C3
Do not bleach the microfibre cover z!
Do not tumble dry the microfibre cover z!
Do not iron the microfibre cover z!
Material: 88% polyester / 12% cotton
Cleaning the appliance
For thorough cleaning, dismantle the appliance:
1) Press the ridged area on the underside of the
vacuum attachment 1 and pull the vacuum
attachment 1 off the appliance . Clean the
vacuum attachment 1 with a damp cloth . If
required, use some mild detergent on the cloth .
2) Press the release button 9 and remove the dirt
container 2 from the motor unit 7 . Now pull
the liner of the dirt container 2 carefully out
through the nozzle 4 . Rinse the dirt container
2 and the liner with fresh water and, if neces-
sary, with a mild detergent .
3) Wipe the motor unit 7 off with a damp cloth .
If required, use some mild detergent on the
cloth . Dry the motor unit 7 .
4) Then reassemble the appliance:
–
Push the liner into the dirt container 2 .
Ensure that the edges of the liner lie flush on
the edge of the dirt container 2 .
–
Replace the dirt container 2 on the motor
unit 7 by pushing the front part into the
motor unit 7 and then pushing the rear part
downwards so that the dirt container 2
clicks firmly into place .
–
Push the vacuum attachment 1 onto the
motor unit 7 .
■
Wipe the charger t with a damp cloth . Ensure
that the charger t is completely dry before
reconnecting it to the mains .
Storage
■
Store the cleaned appliance in a clean, dust-free
and dry location .
GB │ IE │ NI │ CY
│
7
■