Prior To First Use; Assembling The Appliance; Operation; Cleaning - Silvercrest SFR 3.7 C3 Operating Instructions Manual

Prior to first use

Assembling the appliance

1) Remove all packaging materials from the
appliance .
2) Push the vacuum attachment 1 onto the motor
unit 7 .
NOTE
► The appliance batteries are not charged on
delivery . Before using the appliance for the
first time, the batteries must be charged for
2 .5 hours .
3) Charge the appliance (see Chapter "Charging
the appliance") .
The appliance is now ready for use .

Operation

ATTENTION! DAMAGE TO PROPERTY!
► Do not use foaming, corrosive, aggressive,
abrasive or chemical cleaning agents .
These can damage the appliance .

Cleaning

1) Set the tip of the spray nozzle q to STREAM
(jet) or SPRAY (fine water mist) .
2) Attach the spray nozzle q to the wiping attach-
ment 0 .
3) Place the positioning ring w over the tube and
push it onto the wiping attachment 0 so that
it clicks into place . The spray nozzle q is now
enclosed by the wiping attachment 0 and the
positioning ring w .
4) Fill the spray bottle with water and, if desired,
with a cleaning agent suitable for window
cleaning e .
5) Screw the spray nozzle q with the fitted
wiping attachment 0 onto the spray bottle e .
6) Pull the microfibre attachment z over the
retainer on the wiping attachment 0 and
secure it with the velcro fastener .
7) Spray the surface that you wish to clean .
8) Using the microfibre attachment, z wipe over
the sprayed areas and loosen any stubborn dirt .
■ 6 │ GB │ IE │ NI │ CY

Vacuuming

1) Press the On/Off switch 6 . The control lamp
5 lights up blue .
NOTE
► If the indicator light 5 flashes red during
use, this indicates that the appliance needs
to be charged (see chapter on "Charging the
appliance") .
ATTENTION! DAMAGE TO PROPERTY!
► Move the blade of the vacuum attachment 1
slowly from top to bottom across the wet sur-
faces . Non-compliance can lead to damage
to the appliance .
2) Move the blade of the vacuum attachment 1
slowly from top to bottom across the wet
surfaces . The moisture is removed and sucked
into the dirt container 2 .
NOTE
► Never drag the blade sideways across wet
surfaces . Doing so prevents the water from
being vacuumed up; instead, it runs off the
side of the blade .
3) After you have finished a section, always start
again at the top .
ATTENTION! DAMAGE TO PROPERTY!
► Only continue working until the MAX mark
on the dirt container 2 is reached . Then
switch off the appliance and empty the dirt
container 2:
Remove the plug 3 on the dirt container 2 .
Pour away the dirty water and reclose the dirt
container 2 . You can then resume working .
NOTE
► If any dirty water remains in the dirt container
2, you must remove this from the appliance . To
do this, press the release button 9 and remove
the dirt container 2 from the motor unit 7 .
Turn the dirt container 2 so that the nozzle 4
is pointing diagonally upwards . Now pull the
liner carefully out through the nozzle 4 and
shake out the remaining dirty water .
SFR 3.7 C3