1.3 Basic Software Installation
START
Set the SENS switch
corresponding to the system
to have DATA installed
(CPU0, CPU1) to "3" on the
EMA card.
Insert the FD "Basic
Software #2" into the FDD.
*
Flip the MBR key on the CPR
[DOWN → UP → DOWN].
Repeat
*
Basic Software #3 ~ Last
FD
END
Removal or Make Busy of the HFD card
WARNING
is not allowed while the Floppy Disk or
Hard Disk is being accessed.
<7-Segment LED Indication on the EMA card>
ND-70373 (E)
SYSTEM STARTUP
ATTENTION
Contents
Static Sensitive
Handling
Precautions Required
<Install End>
CHAPTER 3
Revision 1.0
Page 21