Silvercrest SGM 110 A1 Operating Instructions Manual page 19

–
Wipe the plastic part of the motor unit
cloth. For stubborn dirt, add a mild detergent to the cloth.
For hard-to-reach corners, use the supplied cleaning brush .
Remove any detergent residue with a damp cloth and wa-
ter only . Make sure that the seal ring is properly placed in
the plastic part of the motor unit
–
Put both parts back together so that the - mark on the
lower part (metal) points at the - mark on the drive unit
Lock the parts by turning the lower part (metal) counter-
clockwise. Make sure you turn the lower part (metal) as
far as possible in a counter-clockwise direction to prevent
leaks.
Rinse the output unit
■
Dry all parts well. All parts must be completely dried before
■
reassembling the appliance.
Take special care to ensure that the metal contacts on the drive unit
inside the casing
malfunction!
■ 16 US-EN
│
Fig. 6
in warm water and add a mild detergent.
are not damp. Dampness may cause the appliance to
with a damp
(see Fig. 6) .
SGM 110 A1
.
and