Aop Settings - Siemens SINAMICS S120 Operating Instructions Manual

● Manual
After selecting manual scaling and confirmation with "OK," a window opens in which the
maximum and minimum limits for scaling can be set.
Figure 4-7
After setting and applying the limits, you switch to the curve recorder and manual scaling
is used.
If the current measured values are outside the displayable range, the range will
automatically be extended.
Note
Changing the parameter for the curve recorder in manual scaling
When the parameter for the curve recorder is changed the following occurs with manual
scaling:
• If the actual parameter has lower values than the currently set scaling, the scaling will
• If the current parameter has higher values than the currently set scaling, the scaling
Help for the curve recorder can be opened with key F1.
The curve recorder is exited by pressing the MENU button.
Note
Data is not recorded
The values displayed in the recorder are not recorded and saved, they are only used for
display until the screen form is exited.
4.6.4

AOP settings

Control settings
Defines the settings for the control keys in LOCAL mode.
(→ see section "Operation via the operator panel (LOCAL mode)").
Cabinet Modules Operator Panel AOP30
Operating Instructions, 04/2014, A5E03263551A
Curve recorder - manual scaling
be retained.
will be adjusted automatically.
Control via the operator panel
4.6 Menu commissioning / service
45