Table of Contents
Advertisement
Figure 1-2. Loading a User's Application via Serial Bootloader
1.1.2.1
EVM Jumper Settings
1.1.2.1.1
56F801
To load the Bootloader into the 56F801 board, the following jumper settings are required:
•
Do not set jumper JG5, "Enable on-board Parallel JTAG Host Target Interface"
To start a previously loaded Bootloader on the 56F801 board, the following jumper settings are
needed:
•
Set jumper JG5, "Enable on-board Parallel JTAG Host Target Interface"
1.1.2.1.2
56F803
To load the Bootloader into the 56F803 board, the following jumper settings are required:
•
Remove jumper JG2, "Enable on-board Parallel JTAG Host Target Interface"
•
Set jumper JG4, "Select DSP's Mode 0 operation upon exit from reset"
To start a previously loaded Bootloader on the 56F803 board, the following jumper settings are
required:
•
Set jumper JG2, "Enable on-board Parallel JTAG Host Target Interface"
•
Set jumper JG4, "Select DSP's Mode 0 operation upon exit from reset"
1.1.2.1.3
56F805
To load the Bootloader into the 56F805 board, the following jumper settings are required:
•
Set jumper JG7, "Select DSP's Mode 0 operation upon exit from reset"
•
Set jumper JG9, "Enable RS-232 output"
•
Remove jumper JG5, "Enable on-board Parallel JTAG Host Target Interface"
MOTOROLA
Freescale Semiconductor, Inc.
S-Record
RS-232
Bootloader
For More Information On This Product,
Go to: www.freescale.com
56F8xxEVM
1-3
Advertisement
Table of Contents
