Loading Printing Paper - Sharp UX-CD600 Operation Manual

Loading Printing Paper

Loading Printing Paper
You can load letter or legal size paper in the paper tray. Recommended paper
weight is 20-lb. Copy Bond. The maximum number of sheets is as follows:
Letter size:
Legal size:
1
Fan the paper, and then tap the edge
against a flat surface to even the stack.
Make sure the stack edges are even.
2
Insert the stack of paper into the tray, PRINT SIDE DOWN .
•
If paper remains in the tray, take it out and combine it into a single stack
with the new paper.
•
Be sure to load the paper so that printing takes place on the print side of
the paper. Printing on the reverse side may result in poor print quality.
•
GENTLY LOAD PAPER INTO THE PAPER TRAY .
•
DO NOT FORCE IT DOWN INTO THE FEED SLOT .
The stack
should not
be higher
than this line
Note: Do not use paper that has already been printed on, or paper that is curled.
Note: If at any time the display shows the
message at right, check the printing paper. If the
tray is empty, add paper. If there is paper in the
tray, take it out and then reinsert it. When you are
finished, press
28
Approx.
50 sheets (20-Ib. copier paper at room temperature;
maximum stack height should not be higher than the line on the
tray)
5 sheets
START/MEMORY
.
ADD PAPER &
PRESS START KEY