Pioneer SGX-CA600 User Manual page 333

Remove the lithium-ion battery by the following procedure.
Caution
! When removing the battery from the device, be careful not to injure your-
self with a tool, etc.
Please never attempt to disassemble the device other than to dispose of
the battery.
1
Remove the four screws with a Phillips screwdriver and
then insert a flat-blade screwdriver from the groove at the
front and use it to raise up the back cover.
When removing the screws of the USB connector cover, take care not to
deform the screw drive.
②
2
Disconnect the cable of the lithium-ion battery from the
board and detach the entire board from the front.
When disconnecting the lithium-ion battery cable, please hold and pull
the connector without pulling the cable part.
Pulling the cable part may cause a disconnection.
3
Insert a finger from the side direction of the lithium-ion bat-
tery and peel off the tape.
Peel off the tape that secures the lithium-ion battery to remove the
battery.
Be careful not to damage the lithium-ion battery.
①
①
333