D-Link AC1200 User Manual page 29

Section 4 - Configuration
Enable Toggle this switch to enable the connection. This is enabled by default.
Connection:
Disabling this feature may disable your Internet connection.
Authorization via 802.1x Protocol
Enable Toggle this switch to enable 802.1x authentication over WAN. This
authorization via
setting is disabled by default.
802.1x protocol:
If you have enabled 802.1x above, choose from EAP-MD5, EAP-TTLS/
Authentication
method: CHAP, EAP-TTLS/MS-CHAP, or EAP-TTLS/MS-CHAPv2.
Login: Specify a username for 802.1x authentication.
Password: Specify a password for 802.1x authentication.
Miscellaneous
NAT:
Toggle this switch to enable Network Address Translation (NAT). This
setting is enabled by default.
Firewall:
Toggle this switch to enable firewall functionality. This setting is
enabled by default.
RIP:
Toggle this switch to enable Routing Information Protocol (RIP). This
setting is disabled by default.
Ping:
Toggle this switch to enable WAN Ping. This setting is disabled by
default.
Isolate
Toggle this switch to enable connection isolation. This setting is
connection:
disabled by default.
D-Link DIR-1210 User Manual
Dynamic IPv4 (cont)
25