D-Link AC1200 User Manual page 79

Section 4 - Configuration
Source IP Address
Choose Range or single IP address to enter a specific IP address or
Set as:
ranges for the source filter. Choose Subnet to specify a subnet only.
If you have selected Range or single IP address, specify an IP address
Start/End IPv4/
IPv6 address:
range for the source filter. To specify a single address, use only the
Start IPv4/IPv6 address field and leave the End IPv4/IPv6 address
field blank.
Subnet IPv4/IPv6 If you have selected Subnet, enter the source subnet to filter.
address:
Ports
Destination port: Specify the destination port or ports to which the filter will apply.
Specify multiple ports by separating them with commas. Specify port
ranges by separating the beginning and end of the range with a colon.
Set source port Toggle this switch to specify source ports to which the filter will apply.
manually:
Source port: If Set source port manually has been enabled, specify the source
port to which the filter will apply. Specify multiple ports by separating
them with commas. Specify port ranges by separating the beginning
and end of the range with a colon.
Click Apply when you are done.
D-Link DIR-1210 User Manual
IP Filter Create/Edit (cont)
75