Network; Ipv4 - D-Link AC1200 User Manual

Section 4 - Configuration
This section will allow you to change the local network settings of the router
and to configure the DHCP settings. In the Settings menu on the bar on
the top of the page, click Network. Click IPv4 and IPv6 to configure their
respective settings.
Local IP Address
IP Address: Specify the IP address of the router. The default IP address is
192.168.0.1.
If you change the IP address, once you click Apply you will need to
enter the new IP address in your browser to access the configuration
utility.
Subnet Mask: Specify the subnet mask of the router. The default subnet mask is
255.255.255.0.
Gateway IP For Access Point, Repeater, and Client modes only.
Address: Specify the gateway IP address which is used by the router to connect
to the internet. (Optional)
Device domain Specify the device domain name and URL to access the management
name: utility. The default URL is http://dlinkrouter.local/
Dynamic IP Addresses
Mode of Dynamic Select Disable, DHCP server, or DHCP relay. The default setting is
IP address
DHCP server
assignment:
D-Link DIR-1210 User Manual

Network

.

IPv4

68