Melsec-Fx1S/ Fx1N/ Fx1Nc Series - Panasonic GT Series Manual

1.1 MELSEC-FX1S/ FX1N/ FX1NC Series

PLC model selection
Select "Mitsubishi MELSEC-FX Series".
Usable devices
Bit/Word Device
Input Relay
Output Relay
Internal Relay
Bit
Device
State
Timer(contact)
Counter(contact)
Input Relay
Output Relay
Internal Relay
State
Word
Device
Timer(current)
16 Bits Counter(current)
32 Bits Counter(current)
Data Register
Note1) The addresses you can use may differ depending on the model. For details, please see the
manual for the PLC you are using.
Note2) If using an input relay, output relay and auxiliary relay in word units, please set the address in 16
point increments from 000. (X000, X020, X040 ..., M000, M016, M032).
Communication Parameters Settings
The example of communication settings of GT and PLC is shown below.
Setting Values for GT (Set in the configuration setting of GTWIN.)
Item
Baud Rate
Data Length
Stop Bits
Parity
Setting the communication conditions for the PLC
"0" should be stored in D8120. ("0" is the default value, so this setting should not need to be entered by
the user.)
1-2
No.
X0000-X0337
Y0000-Y0337
M0000-M1535
S0000-S0999
TS0000-TS0255
CS0000-CS0255
X0000-X0320
Y0000-Y0320
M0000-M1520
S0000-S0976
TN0000-TN0255
CN0000-CN0199
CN0200-CN0255
D0000-D0999
Setting
9600bps
7
1
Even
Memo
Specify address expression every 20
Specify address expression every 20
Specify address expression every 16 multiples
Specify address expression every 16 multiples