Panasonic GT Series Manual page 22

Bit/Word Device
Input Relay
Output Relay
Internal Relay
Latch relay
Annunciator
Edge relay
Link Relay
Special relay
Link special relay
Step relay
Direct access input
Word
Direct access output
Device
Timer(current)
Retentive timer(Current
value)
Counter(current)
Data Register
Link Register
Link special register
Index register
File Register(for block
number)
File register(for
sequential number)
Special register
Note:
The maximum value that can be set with the GT is described.
-
The range of usable addresses differs depending on the model. For details, please consult the manual
-
for the PLC you will use.
When you use a serial communication module, you will set some parameters (Slot No., Module type,
-
I/O points and Start address etc). Input and output relay from the start address for set points can't be
used.
Although "Mitsubishi MELSEC-A (Computer Link) Series" can be used, the address range is the same
-
as the one for "Mitsubishi MELSEC-A (Computer Link) Series".
1-10
No.
X000000-X001FF
Y000000-Y001FF0
M000000-M032752
L000000-L032752
F000000-F032752
V000000-V032752
B000000-B007FF0
SM000000-SM002032
SB000000-SB0007F0
S000000-S008176
DX000000-DX001FFF
DY000000-DY001FFF
TN000000-TN023087
SN000000-SN023087
CN000000-CN023087
D000000-D025983
W000000-W00657F
SW000000-SW0007FF
Z0-Z15
R000000-R032767
ZR000000-ZR1042431
SD000000-SD002047
Memo
Specify address expression every 0
Specify address expression every 0
Specify address expression every 16
multiples
Specify address expression every 10