Forced engine rpm setting No. 08 (Level 0) < >
Forced setting of setting engine rpm is possible.
1) Forced engine rpm setting display (Level 0)
Displays selection of the forced engine rpm setting at the menu.
2) forced engine rpm setting (Level 1)
Pressing the SET (S007) key in the forced engine rpm setting display mode activates the following display
cycle, which is repeated at 1-second intervals.
(Example: forced engine rpm= 1400min
(Example: Engine rpm= 1400min
(Example: Compressor inlet pressure=0.56MPa)
(Example: Compressor outlet pressure= 0.56MPa)
(Example: Compressor outlet temperature = 85.0°C)
3) Forced engine rpm setting operation (Level 2)
Start operation method
Change operation method : Operating the UP (S005) and DOWN (S006) keys makes it possible to change
End operation method
4) Other
Setting range
Clutch
Rotation restriction
-1
)
: Press the SET (S007) key for one second when forced engine rpm has not been
set. This will fi x the set engine rpm at the forced engine rpm. The forced setting
in progress display appears during this time. (TEST/WARNING LED light)
the setting values.
: Press the SET (S007) key for one second when the forced engine rpm is set.
This cancels the forced setting in progress display, returning to forced setting
select operation. (TEST/WARNING LED off)
: From the lowest to the highest rpm in that machine's control status, measured in
100 rpm units.
: Moves to clutch engaged rpm during clutch work, conducting clutch engaged
operation.
: To protect the compressor, if the compressor inlet pressure is below 0.05MPa,
setting rotation's upper limit is set to 1400min
V–33
-1
)
-1
.