Table of Contents
Advertisement
Chapter 1. Introduction
3.2
Back of the Unit
(1)
Connector for AC adapter (1 No) *1
Power supply connector for AC adapter.
Connected to the optional AC adapter of
NeoFace.
.
Power source connector (1 No) *1
(2)
Power supply connector for Terminal 2 Pin.
Can be connected to the power supply equipment.
(3)
DI/DO connector (1 No)
Connector compatible with Digital INPUT(DI) x4 / Digital
OUTPUT(DO) x4
Can be connected to the devices compatible with contact
connection.
(4)
DI/DO switching switch (1 No)
Switch that switches between the internal power supply
(INT_VCC) or external power supply (EXT_VCC) of the
digital input. Set with internal power supply (INT_VCC) on
the right and external power supply (EXT_VCC) on the
left.
48
(2)
(3)
(1)
(5)
(6)
(7)
NeoFace Access Control User's Guide
Main Unit Description
3.
(4)
(8)
(5) Unused connector (1 No)
Cannot be used with NeoFace.
Do not connect anything.
(6) Display connector (DP) (1 No)
Connector compatible with display port standards.
Connecting to display complaint to display port
standard is possible.
(7) USB connector (2 Nos)
Connector compatible with USB 3.0. Can be connected
to a USB device.
Lower side is USB 1 and upper side is USB 2.
(8) LAN connector (2 Nos)
LAN
connector
compatible
T/100BASE-TX/10BASE-T.
Right side is LAN1 and left side is LAN2.
*1 Only one out of two the connectors of (1) and (2) can be
used. Both cannot be used at the same time.
with
1000BASE-
Advertisement
Table of Contents
