Table of Contents
Advertisement
Chapter 2 Installation and Connection
4. Connections
Connecting the peripheral equipment to NeoFace. Connectors to which various peripheral devices can be attached are
provided in NeoFace.
4.1
Bottom Panel
When connecting cables and connectors, remove the bottom panel with the following procedure. Wiring of the cables
connected to the bottom of the main unit should be done after passing through the holes of the body panel removed
beforehand.
1.
To prevent damage to NeoFace or LCD, place the body with the front side down on a flat soft object
2.
Remove the six screws that secure the bottom panel and remove the bottom panel
* The screws at the back side are covered with rubber covers. Remove the rubber covers and then loosen the screws.
Hex driver is required to remove the screws on the back panel, and plastic screwdriver is required to remove the
screws at the bottom.
3.
After connecting the peripheral devices, attach the bottom panel in the reverse order of removal.
NeoFace Access Control User's Guide
Connections
4.
57
Advertisement
Table of Contents
