Table of Contents
Advertisement
Chapter 2 Installation and Connection
Setup
5.
5.2
Initial Setup
During factory shipment and when the recovery disc is used, the following screen is displayed after OS start-up and then
the initial setup screen will be displayed.
Initial setup must be done with the network (LAN cable) connected.
Connect the LAN cable to the LAN 1 port of NeoFace Access Control.
* If the customers want to change the system configuration after completion of initial setup, NeoFace must be returned to
the factory shipment state using the recovery disc and this procedure must be performed again.
67
NeoFace Access Control User's Guide
Advertisement
Table of Contents
