Setup - NEC EGW101 User Manual

Chapter 2 Installation and Connection

5. Setup

Three system configurations are possible with NeoFace Access Control.
The maximum number of registrants for each configuration and terminals used for registration of persons entering and exiting
are as shown in the table below.
(1) NeoFace Access Control 1 unit operated
(2) NeoFace Access Control 2 to 5 units operated
(Master / slave configuration)
(3) NeoFace Access Control Manager
– NeoFace Access Control (to 100-unit
configuration)
The following method is used to turn ON the power supply.
Check that the AC adapter is properly connected and then press the power switch at the lower front side of NeoFace.
When the power supply is ON, power indicator lights up in green.
Maximum number of registrants
*Default user
(Including NFAC administrators)
5000 people
5000 people
10000 people
Power switch
NeoFace Access Control User's Guide
Setup
5.
Terminals that registers
persons entering and exiting
NeoFace Access Control
(master)
NeoFace Access Control
(master)
NeoFace Access Control
Manager
* Batch registration is possible
Power lamp
65