Siemens SIMATIC S7-1500 Automation System System Manual page 69

Preparing front connectors for I/O modules with shield contact element
1. Remove the connection separator from the lower part of the connector (Figure 1).
2. Insert the power supply element (Figure 2).
3. Insert the shielding bracket from below into the guiding groove of the front connector until
4. Place the included cable strain relief (cable tie) for the cable harness into the front
5. Swing the front cover up until the front cover latches (Figure 5).
S7-1500 Automation System
System Manual, 01/2013, A5E03461182-01
it latches into place (Figure 3).
connector (Figure 4).
Figure 6-9 Preparing front connectors for I/O modules with shield contact element (1)
6.8 Front connector for the I/O modules
Wiring
69