DeviceNet line with DNP31 directly connected to UMC100.3 in a drawout system
The following figure shows a simplified diagram on how to connect the UMC100.3 to a DeviceNet network. Required grounding
of the DeviceNet cable is not shown in this figure.
Ground wire and cable shield should be connected to prevent common mode voltage
between the network devices from drifting outside the allowable limits.
DNP31.0 Data sheet
DeviceNet
Master
Termination active
DeviceNet Cable
UMC100.3 and DNP31
mounted in drawer
- 10 -
Issue: 09.2015