Table of Contents
Advertisement
Remove the HP 16533/34A module and set the
3
PROTECT/UNPROTECT switch to the UNPROTECT position. On a
multi-card module, the PROTECT/UNPROTECT switch on all cards
must be set to UNPROTECT.
Reinstall the modules and filler panels.
4
Apply power to the HP 16500 mainframe. Allow the HP 16533/34A
5
module to warm up approximately 30 minutes before doing the
following steps in the self calibration.
Installation and Operator's Service
Set up the equipment
11–11
Advertisement
Table of Contents
