PS4210 Installation Guide
Figure 6: Recommended Network Configurations
Connect and Secure the Power Cables
Obtain the power cables that were shipped with the array. If the array was not shipped with
power cables, contact your PS Series support provider or reseller for power cable information.
1. Make sure that the power switch is in the OFF (O) position before connecting the power
cables.
2. Connect the power cables to the power supplies as shown in .
3. Secure the power cables to the system:
a. Secure the power cables firmly to the bracket next to the system power receptacle
using the provided hook-and-loop strap.
b. Make sure the strap is tightly bound to the bracket anchor point (remove any slack).
c. Bias the power cable toward the strap and wrap the strap tightly around the cable
against the shoulder of the power cable connector.
4. Attach the power cables to a power source:
3 Connecting the Array Cables
11