Dell EqualLogic PS4210 Installation And Setup Manual page 28

PS4210 Installation Guide
Searching to see if the group exists. This may take a few minutes.
The group does not exist or currently cannot be reached. Make sure you have
entered the correct group IP address and group name.
Do you want to create a new group (yes | no) [yes]? yes
Group Configuration
group1
Group Name:
Group IP address: 192.17.2.20
Do you want to use the group settings shown above (yes | no) [yes]: yes
Password for managing group membership:
Retype password for verification:
Password for the default group administration account:
Retype password for verification:
Saving the configuration ...
Waiting for configuration to become active......Done
Group member member1 now active in the group.
Group group1 has been created with one member.
Use the Group Manager GUI or CLI to set the RAID policy for the member. You can
then create a volume that a host can connect to using an iSCSI initiator.
group1>
Using the Remote Setup Wizard to Configure the Soft-
ware
The Remote Setup wizard is located on the Host Integration Tools CD-ROM and must be
installed on a Windows or a Linux computer. The Host Integration Tools User Guide provides
detailed information about using the full capabilities of the Remote Setup wizard.
To run the Remote Setup wizard, follow these steps:
1. Use a computer that meets the requirements in Choose a Configuration Method on page
2. Obtain the Host Integration Tools CD-ROM from the shipping box, or download the Host
Integration Tools kit from the support website.
3. Install the Remote Setup wizard following the instructions in the Host Integration Tools
documentation.
4. Start the Remote Setup wizard by clicking:
Start, Programs, EqualLogic, Remote Setup Wizard
5. In the Welcome dialog box, select
If you cannot contact the array, check the network configuration. You might need to
Note:
use the
setup
6. Select the array that you want to initialize and click
7. In the Initialize Array dialog box, enter the array configuration from Collect Configuration
Information on page
.
Next
8. In the Create a New Group or Join an Existing Group dialog box, enter the group
configuration information and click
9. Click to exit the wizard.
Finish
If you added the array to an existing group, you must set the member's RAID policy in order to
use the disk storage. Go to Set the Member RAID Policy on page
If you created a new group, go to Storage Allocation on page
20
Initialize a PS Series array
utility to configure the software.
17 and choose to create a group or join an existing group. Then, click
.
Next
4 Software Configuration
and click
.
Next
21.
23.
17.
.
Next