Siemens SIMATIC S5 Manual page 309

Utilization of the Test Program
Handling steps
Proceed as follows when you use the test program:
1. You can load the entire file for the test program in the CPU after an over-
2. Next, assign the values for variables and parameters to the message fra-
3. Once you have pre-assigned all above-mentioned message frames, you
4. The individual functions are now accessible via the inputs E 4.0 through
5. Select the required parameter setting method via input E 7.0. If a parame-
Note
The test program uses indirect parameter setting in the OB 100 startup orga-
nization block. In cyclic operation, the parameter setting method can be
changed via input E 7.0.
If a parameter setting error with an error number 1 through 8, 17 or 23 through
26 occurs during execution of the FC 182, a cold restart must be performed after
the fault has been eliminated.
IP244
C79000–B8576–C866–01
all reset of the CPU has been performed.
mes T no. 0..14 in DB 162, T no. 15 in DB 163 and T no. 30..42 in
DB 164. Enter '0' for the setpoint in DBW n+0 of unused controller chan-
nels. In addition, you must select the controller type (two-step/three-step
controller) in the control byte 1 (DBB n+8).
may trigger a restart. The RUN LED 'R' at the top left of the front panel
lights up to indicate that the module parameters have been set.
E 5.7 and E 7.5.
ter setting error occurs during the execution of the test program, the error
number will remain after the fault has been eliminated until it is cleared
via input E 7.7.
FC162
7–31